52mm Fuel Level Gauge with Digital Display
A 52mm fuel gauge with a digital display, reading tank level as a clear 0–100% figure rather than a needle. It works with resistance senders — including the Wema S3 and S5 — and any other sender with a matching resistance range.
The default is the European 0–190 ohm range; an American 240–30 ohm version is available on request. What matters is that the gauge and sender share the same range — European vs American resistance explained → shows how to check before you order.
- 52mm digital fuel level gauge, 0–100% readout
- Pairs with S3, S5 or any matching resistance sender
- European 0–190Ω (American 240–30Ω on request)
- Red or amber backlight, wire-selectable
- 12V or 24V (24V needs a dropping resistor or voltage regulator)
- IP67, fully corrosion protected; resistant to ozone, UV and saltwater
- Low draw — 0–130mA
- Choice of black or white face, with a stainless, black or white bezel
Fitting: 52mm cut-out, 56/62mm outer, 60mm depth — allow at least 55mm clearance behind the panel.
Running 24V? Use the dropping resistor, or feed the dashboard from a voltage regulator for a steadier supply (why this matters →). Prefer a traditional dial? See the analogue fuel gauge →, or browse all level gauges →.
A 52mm fuel gauge with a digital display, reading tank level as a clear 0–100% figure rather than a needle. It works with resistance senders — including the Wema S3 and S5 — and any other sender with a matching resistance range.
The default is the European 0–190 ohm range; an American 240–30 ohm version is available on request. What matters is that the gauge and sender share the same range — European vs American resistance explained → shows how to check before you order.
- 52mm digital fuel level gauge, 0–100% readout
- Pairs with S3, S5 or any matching resistance sender
- European 0–190Ω (American 240–30Ω on request)
- Red or amber backlight, wire-selectable
- 12V or 24V (24V needs a dropping resistor or voltage regulator)
- IP67, fully corrosion protected; resistant to ozone, UV and saltwater
- Low draw — 0–130mA
- Choice of black or white face, with a stainless, black or white bezel
Fitting: 52mm cut-out, 56/62mm outer, 60mm depth — allow at least 55mm clearance behind the panel.
Running 24V? Use the dropping resistor, or feed the dashboard from a voltage regulator for a steadier supply (why this matters →). Prefer a traditional dial? See the analogue fuel gauge →, or browse all level gauges →.