ANALOGUE HOLDING TANK LEVEL GAUGE
- Black water level
- 52mm diameter gauge
- 12v/24v
- Marine grade - IP67 waterproof
- 240-30 ohms
- Backlight - Red or Yellow
- Choice of face & bezel colours
Analogue holding tank (black water) level gauge for monitoring of tank level.
Works with S3-H senders.
Available in all standard face and bezel colours to ensure continuity with all other gauges.
INSTALLATION̴
WIRING INSTRUCTIONS
Yellow - yellow̴ light
Orange - red light
Black - to sensor
Red - to positive (+)
Blue - to ground (-)
1. Cut a 52mm (2 1/16") diameter hole in the panel.
You will need a minimum clearance of 55mm (2 3/16") behind the panel to fit the gauge.
2. Remove fastening ring and insert gauge through panel from the front, fit and tighten fastening ring from the rear.
3. Connect wires according to wiring diagram.
Select either Orange or Yellow wires for backlighting. Wire colour corresponds with backlight colour.
* Note the use of dropping resistors for 24V circuit.
4. Insert wire harness into port at the back of the gauge.
Here you can find answers to some popular questions, for anything else please contact us by email or by phone and we'll be happy to help.
- How to identify and order a new or replacement level sender
- What is NMEA 2000?
- How to decide the length of a sender
- What's the difference between the S3 and S5 senders?
- How to test a sender
- How to test a gauge
- What's the difference between European and American resistance?
- Connecting two senders to one gauge
- Connecting two gauges to one senders
- Tachometer FAQ's
- Replacing a floating arm sender
- Sender Identification Chart
- Discontinued Senders - a list of discontinued senders